Mi 4x Frp Remove Done By UMT

Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM4)
Driver Info : Huawei Incorporated, qu_usb_serial.sys, 2.1.1.0
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1B00600 [8937] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD37993 0D5891E3D8240B
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8937_003]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8937, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi 4X [msm8937]
Software : N2G47H, V10.1.1.0.NAMMIFI [Wed Nov 14 19:06:32 WIB 2018]
Android Ver. : 7.1.2
Patch Level : 2018-10-01
Resetting FRP Lock......Done
Operation Finished.
QcFire Ver. 3.9