mi 8 lite account done .. guide

hi,

reset account with qcfire

TEST POINT
https://ibb.co/F5P8rCn

log:
Operation : Reset Mi Account
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21 F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_022]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 128 GB
LU Count : 1 [0x0E8F8000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi MI 8 Lite
Software : OPM1.171019.019, V10.2.2.0.ODTMIXM [Tue Jan 15 10:53:40 WIB 2019]
Android Ver. : 8.1.0
Patch Level : 2018-12-01
Resetting Mi Account Data...Done
Preparing Data...Done
Formatting Userdata...Done
When phone is completely ON, connect to Internet and add Mi Account.
-------------- INFORMATION --------------
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.
QcFire Ver. 3.8

fix wifi and bt ...

flash only persist.img

qcfire... advance flasher ... connect using "test point"..... tick only persist ... load pesist.img

link to persist.img

https://mega.nz/#!OhkVgAZJ!t53LuRtCt...-Dm3TRC2448URI

then flash selectd

log:
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM343)
Driver Info : Qualcomm Incorporated, qu_usb_serial.sys, 2.1.2.0
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21 F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_022]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 128 GB
LU Count : 1 [0x0E8F8000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Parsing Partition Entries...Done
Writing [persist.img] -> [persist] ...Done
Operation Finished.
QcFire Ver. 3.8

thx umt

Attached Images

2.jpg (311.3 KB)