LG D392 Unable to Flash by QC Fire

Received set in 9008 Condition, Tried extracting firmware by LG tool & then flashing by QC Fire...

But i am unable to flash it...

Log

Code:

---


Operation        : Flash
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port        : Qualcomm HS-USB QDLoader 9008 (COM104)
Driver Info        : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID        : E1507000 [8916] 00000000
OPK_DATA        : 9CBA94693C2333A562BCF0E0E981C558748817D002F543B2A26AB1B4B3F1CF9E
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8916_014.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware        : 8916, eMMC, 8 GB
LU Count        : 1 [0x00E90000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info        : In: 65536 [4096], Out: 16384, Sector Size: 512
Writing [PrimaryGPT_0.bin] -> [PrimaryGPT] ...Done
Writing [sbl1_1024.bin] -> [sbl1] ...Done
Writing [tz_2048.bin] -> [tz] ...Done
Writing [hyp_3072.bin] -> [hyp] ...Done
Writing [rpm_4096.bin] -> [rpm] ...Done
Writing [aboot_5120.bin] -> [aboot] ...Done
Writing [sbl1bak_10240.bin] -> [sbl1bak] ...Done
Writing [tzbak_11264.bin] -> [tzbak] ...Done
Writing [hypbak_12288.bin] -> [hypbak] ...Done
Writing [rpmbak_13312.bin] -> [rpmbak] ...Done
Writing [abootbak_14336.bin] -> [abootbak] ...Failed
Operation Finished.
Module Ver. 2.3

---