g610f galaxy j7 prime frp success

Welcome to Octoplus Box Samsung software version 2.6.9
-----------------------------------------------------------------------------------
To connect SM-G928T phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3.Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
To connect SM-T211 phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3.Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
To connect SM-G928T phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->More->About Device.
3.Tap on "Build number" 7 times to enable developer options.
4. Go to Menu->Settings->More->Developer options.
5. Turn on "USB Debugging" option.
-----------------------------------------------------------------------------------
Platform: Samsung Android
Selected port: COM1
Selected model: SM-G610F
Operation: Reset FRP - UART EMMC
Searching for UART interface.. COM19
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...OK
Reading data...
Checking operation...
This version of "sBoot" is not supported, try to downgrade "sBoot"!
Operation was failed!
Performed by 2.6.9 Software version.
Selected AP file: D:\g610f custom\COMBINATION_ODD_FA60
_G610FDDU1API2_ODDFA60_G610FDDU1API2_CL9139094
_QB10968271_REV00_user_mid_noship.tar.md5
Please put the phone into Download Mode and connect USB cable.
To put SM-G610F into Download Mode, You have to perform the
following steps:
1. Reconnect the battery.
2. Press and hold "Volume-" + "Home" + "Power ON" keys.
3. When phone turns on, press "Volume+" key.
Found phone on
Advanced mode!
Firmware write started.
Writing BOOTLOADER section...
BOOTLOADER section has been written successfully.
Firmware writing successfully completed.
Performed by 2.6.9 Software version.
-----------------------------------------------------------------------------------
Platform: Samsung Android
Selected port: COM1
Selected model: SM-G610F
Operation: Reset FRP - UART EMMC
Searching for UART interface.. COM19
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Rebooting phone in Upload Mode...OK
Please connect phone to USB cable..
Searching for a phone. Please wait...OK
Reading data...
Checking operation...OK
Searching for UART interface.. COM19
Connect Samsung Micro UART cable(with 525K resistor), press and
hold "Vol-" + "Power" buttons for 15-20 seconds
Searching for device. Please wait...
Phone found.
Resetting FRP lock (1/4 attempt)..success
FRP / Reactivation lock is successfully reseted!
Performed by 2.6.9 Software version.