Exceeded its maximum estimated device life time

Setting interface to EasyJtag2/ISP
Setting bus width to 1 Bit
Setting frequence to 36 Mhz
CMD Pullup Level: 1774 mV
CMD Active Level: 1864 mV
EMMC Device Information :
EMMC CID: 90014A483847316505076BA3E07872BD
EMMC CSD: D02701320F5903FFFFFFFFEF8A4040D3
EMMC Manufacture : SKHYNIX , EMMC NAME: H8G1e , HEX: 483847316500 , S/N: 6BA3E078 , rev. 0x07
EMMC Manufacture ID: 0x90 , OEM ID: 0x4A , Device Type: BGA (Discrete embedded) , Date: 7/2015
EMMC ROM 1 (Main User Data) Capacity: 7456 MB (0001D2000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 4096 KB (000000400000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 KB (000000400000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.7 (MMC 5.0, MMC 5.01)
Boot configuration [PARTITION_CONFIG]: 0x08 , Boot from: ROM2 (Boot partition 1)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x07
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Device can have extended partitions attribute
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: H8G1e_6BA3E078_20190222_184730.extcsd
EMMC Init completed.

Warning: Health report is very BAD

Device Life Time Estimation (MLC) [269]: 0x0B Exceeded its maximum estimated device life time
Device Life Time Estimation (SLC) [268]: 0x01 0% - 10% device life time used
Pre EOL information [267]: 0x03 Urgent


How to work on it? Do i need to replece emmc?:confused: