easy jteg gpg (old hadware) not connecting any emmc

Z3X EasyJtag Software ver. 3.2.0.3
Loading eMMC GEN1 Firmware... IO: 3300 mV
Box S/N: 0F0F1010BF8FEF3B, ,FW Ver.: 01.63
CMD Pullup Level:391 mV
CMD Active Level:2846 mV
Box IO Level:3300 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]
Done.

Z3X EasyJtag Software ver. 3.2.0.3
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0F0F1010BF8FEF3B, ,FW Ver.: 01.63
CMD Pullup Level:381 mV
CMD Active Level:2330 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: OCR Ready Timeout Error [Check VCC or eMMC DEAD]
Done.

i m using this adopter with a charger

https://www.5g-m.com/it/boxes-dongle...1-adapter.html