ZTE z959 frp unlock done by QCfire

procedure:
turn off the phone.
put phone to ftm mode (hold vol. down then connect the cable)
when the phone is in ftm mode, go to qcfire/ read and tools/ click FTM2EDL
the phone will boot to edl 9008 diag port.
click reset FRP.

logs:
Operation : Reset FRP
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM76)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.1.2
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1009600 [8909] 00000400
OPK_DATA : D64F31F1F574B2C3A0A679CA104A03C0F20B4833F5E2F96A2B 56AA09B374C8A6
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8909_044.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8909, eMMC, 16 GB
LU Count : 1 [0x01D1F000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : ZTE Z959 [msm8909]
Software : Z959V1.10.21, 20180717.180716 [Tue Jul 17 18:08:12 CST 2018]
Android Ver. : 5.1.1
Patch Level : 2018-04-05
Resetting FRP Lock......Done
Operation Finished.
Module Ver. 2.6