Can't init device, Reason: CMD Timeout Error

https://s13.postimg.org/w5m478y9j/screenshot.png


https://s13.postimg.org/vg3buufpj/ph...1_12-02-16.jpg


all solder war is good



Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Compression is ON
Z3X EasyJtag Software ver. 2.9.0.0
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0404111A58FD0E5F, ,FW Ver.: 01.62
CMD Pullup Level:1722 mV
CMD Active Level:2165 mV
Box IO Level:2800 mV
CLK Rate:14000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
Can't init device, Reason: CMD Timeout Error
Done.